T8000C

T-8000C system features

1、32—256 Gray, Gamma correction procession software

2、Combined with video encoding and broadcasting software LedEdit , support rules and specific-shaped handle, and other points, line lights source

3、Eight-port output，port 512/1024 lights

4、Playback content stored in SD card, can stand-alone play, also multiple cascade

NOTE：T-8000C port 512 lights, the playback speed of up to 30 frames / sec, the port more than 512 lights, the frame rate with the increase in the number of lights automatically reduced.

5、When multiple cascade, only the first controller buttons work, followed by sub-control buttons are automatically shielded, at this point can adjust playback file and speed through the first controller

NOTE：At this time the first controller's buttons can control all sub-control keys

Support chips：

①TTL signal（245 signal）：

COM	GND(ground)
DAT	Signal
CLK	Clock

NOTE：TTL signal output for the controller and the lighting must be common ground (that is, the ground controller output and the lamp connected to the ground together)

②If the customer needs can also be replaced with differential output, differential outputs defined as (485 differential)：

COM	GND(ground)
DAT	Differential signal A(or DAT+)
CLK	Differential signal B(or DAT-)

NOTE：Differential signal do not share ground

③If the controller output to the lamp is distant, you can use the current loop output (current loop transmission distance up to 300m), is defined as follows

COM	Common port（not GND)
DAT	Signal
CLK	Clock

NOTE：Use the current loop output,  must connect  a current loop receiver board before the lamp, then connect lamps。

The identity at the top of the controller：

Two Ethernet ports in front of the controller are synchronization signal interface for cascade：

Buttons definition：

NOTE：When multiple cascade, only the first controller buttons work, followed by sub-control buttons are automatically shielded, at this point can adjust playback file and speed through the first controller

NOTE：At this time the first controller's buttons can control all sub-control keys

Special parameters：

   Memory card：

          Type：SD card（if control more lights, suggest using high-speed SD card）

          Capacity：256MB—2GB

          Format：FAT format

          Store file：*.led

   Physical parameters：

             Temperature：-20℃—85℃

             Power supply：DC 5V input

             Power：4W

NOTE：

     To copy files to SD card ，you must first format the SD card, pay attention to is that     each copy must be formatted before. SD card must be formatted as FAT format  

if you need use DMX Console to control, plese see this kits with T8000C