T1000S

1、T-1000S System features

    1、32—256 Gray level，Support software Gamma correction。

2、Support the rules and special-shaped handle.

3、Single-port output，can support 2048 pixels。

4、Off-line(SD Card) control, .

5、T-1000S store a maximum of 16 programs，copy multiple files to the SD card in order,

      after formatting the SD card as “FAT” format.

6、The program must be named in orders . just as ：00_1.led, 01_1.led, 02_1.led.

7、Compatible with single line or double .

NOTE：1.

2. T-1000S must use the new software LedEdit 2012.

2、Support chips：

3、Definition of printing：

Buttons	Meaning
Save SET	Save Settings （ to save current settings file and the playback speed ）。
MODE	Change programs
SPEED+	Speed up	Press speed+ and speed- at the same time the program will play circularly.
SPEED-	Speed down

DC5V	+5V power input
GND	Power GND input
7．5-24V	+7.5-24V power input
POWER	Power indicator
ERROR	Error indicator
SD CARD	SD card slot

TTL signal（245/spi signal）: RS485 signal.

CLK	Clock signal	B	Signal A / DMX+
DAT	Data signal	A	Signal B / DMX-
GND	Signal ground	GND	Signal ground

NOTE：For the TTL(SPI) signal, the controller signal ground must connect to the LED ground directly.

5、         Mode of connection

4. Connection 

1.         Multiple T-1000S controllers can be cascaded together and work synchronously.

2.         T-1000S one TTL(SPI) signal and one RS485 signal port output，can control 2048 pixels/lamps；

3.         When the chip for LED is single line chip just with data, then just need to be connected with DAT and GND of the controller. If the chip for LED is double line chip with DAT and CLK, then need to be connected with DAT, CLK, and GND of the controller.

4.         If you need to use RS485 signal you need to connect controller interface with LED lamps A (DMX+), controller B interface with LED lamps B(DMX-),

5.         If you need to control a new IC type by the controller， software code mode is：T-1000-IC model.

5、         Name of the program：（The rule of how to name the programs：）

The name for NO.2 controller：

“00_1.led” --------- NO.1 program for No.1 controller

“01_1.led” --------- NO.2 program for No.1 controller

“02_1.led” --------- NO.3 program for No.1 controller

  ……

“15_1.led” --------- NO.16 program for No.1 controller

The name for NO.2 controller：

“00_2.led” --------- NO.1 program for No.2 controller

“01_2.led” --------- NO.2 program for No.2 controller

“02_2.led” --------- NO.3 program for No.2 controller

  ……

“15_2.led” --------- NO.4 program for No.2 controller

………

6、Special parameters

    Memory card：

          type：SD card（suggest using high-speed SD card）

          Capacity：128MB—2GB

          Format：FAT

          Store file：*.led

    Physical parameters：

          Working temperature ：-30℃—85℃

          Working voltage：DC5V / DC7.5-24V

          Working power：1W

                    size：L165mm×W80mm×H30mm

                    weight：0.35KG

                    signal port：3pin connect port

Note：

Before copy files to SD card ，The SD card must be formatted as FAT format.